The Sanicondens is a small pump used to pump condensate from condensing boilers, HVAC systems, water heater systems, etc.

The Sanicondens will pump condensate waste up to 15 feet in height and/or 150 feet away from a soil stack.
Discharges the condensate waste through a 3/8 in. vinyl tube. A non-return valve is included on the discharge connection provided with the system.
The small, powerful pumping unit can be floor or wall mounted. It comes with provisions for a ready-to-wire connection to an external overflow switch that will shut down the appliance or alert the consumer in the event of overflow.
Includes all necessary hardware for installation (20 ft of vinyl tubing, inlet adapter, discharge adapter).
Discharges condensate from a condensing boiler or other condensate producing fixtures. The condensate will drain into the system via two 1 in. inlets located on top of the enclosure.


Pump Type: Condensate Pump
Electrical: 120v - 60Hz / 1.5 amps (max)
Motor: 1/30 HP oil-filled thermally protected motor

Operating Temperature: 160 degrees F
Power Cord Length: 60 in.
Noise level (measured at 3 ft): less than 44 dBa (Lp)
Discharge Pipe: 3/8 in. diameter
Discharge Rate at 15 ft: 30 gph
Discharge Rate at 3 ft: 86 gph

Normal Running Time: 3 - 5 seconds (short bursts)
Capacity: 0.5 gallons
Inlets: 1 in. (top)
Method of Activation: Float / microswitch

Connections: Condensing boiler, HVAC systems, air conditioners
Certified by CSA (IPC, NSPC)
Dimensions: 6-5/8 in. x 9-1/2 in. x 5-5/8 in.
Weight: 7 lbs