For residential applications
The Saniswift drain pump is used to pump gray water away from a variety of fixtures in residential applications.
The system is able to discharge the waste up to 14 feet vertical and/or 140 feet horizontal.

Discharges the waste through a 1 in., 1-1/4 in. or 1-1/2 in. rigid pipe. A non-return valve is included on the discharge elbow assembly provided with the system.
Has been designed with a 1-1/2 in. vent connection on top of the lid. All plumbing codes require connection to a vent system. Either inlet located on top of the housing can be used for the vent or as an inlet. Please note that the vent system should be a two-way air vent as air needs to freely flow both ways. Note: The use of mechanical vents, air admittance valves or similar devices is not permitted.
Discharges gray water from a kitchen sink, bath/shower, dishwasher, washing machine (indirect connection via laundry sink). The gray water will drain into the system via three inlets 1-1/2 in. inlets, two low inlets (with built-in check valves) on either side of the housing and one on top of the enclosure.


Pump Type: Drain Pump
Electrical: 120v - 60Hz / 4.5 amps (max)
Motor: 0.3 HP oil-filled thermally protected motor
Capacitor Rating: 30 microfarad
Operating Temperature: 140 degrees F
Power Cord Length: 48 in.
Noise level (measured at 3 ft): less than 44 dBa (Lp)
Discharge Pipe: 1 in. to 1-1/2 in. diameter
Discharge Rate at 14 ft: 18 gpm
Discharge Rate at 3 ft: 29 gpm
Shut-Off Head: 25 ft
Normal Running Time: 3 - 5 seconds (short bursts)
Capacity: 2.75 gallons
Inlets: 1-1/2 in. (sides) 1-1/2 in. vent (top)
Method of Activation: Pressure switch / circuit board
Shower/bathtub Base Height: 6 in. minimum
Connections: Dishwasher, sink, shower, or laundry
Certified by CSA (IPC, NSPC)
Dimensions: 8-3/4 in. x 9 in. x 10-1/4 in.
Weight: 13 lbs