Saniflo Sanicom 1 Drain Pump Heavy Duty/Commercial - 018

Product ID 018 SKU 018
Configure Product
Price:Choose option(s) to show price


For commercial applications requiring gray water removal
The Sanicom 1 Drain Pump was designed to sustain the toughest applications where hot water can be an issue as it is capable of handling up to 194 degrees F.
The system is able to discharge the waste up to 25 feet vertical and/or 250 feet horizontal.

Discharges the waste through a 1 in. rigid pipe. The system includes a rubber discharge elbow that adapts to the discharge pipe as well as a non-return valve. The elbow can be rotated 360 degrees depending on the discharge installation.
Has been designed with a 1-1/4 in. vent connection on top of the system. All plumbing codes require connection to a vent system. If codes require the use of a larger diameter vent pipe, this may be increased by means of an adapter. Please note that the vent system should be a two-way air vent as air needs to freely flow both ways. Note: The use of mechanical vents, air admittance valves or similar devices is not permitted.
The Sanicom 1 drain pump is used to pump gray water away from a variety of fixtures and is capable of handling multiple fixtures simultaneously (commercial kitchens, dishwashers, washing machines, etc.). The gray water will drain into the system via two 2 in. inlets which are on either side of the housing. Note that when draining wastewater into the pump through either of the side inlets, an external check valve (not supplied) has to be installed.


Pump Type: Drain Pump
Electrical: 120v - 60Hz / 10 amps (max)
Motor: 1 HP oil-filled thermally protected motor
Capacitor Rating: 45 microfarad
Operating Temperature: 194 degrees F max
Power Cord Length: 50 in.
Noise level (measured at 3 ft): less than 68 dBa
Discharge Pipe: 1 in. diameter
Discharge Rate at 25 ft: 17 gpm
Discharge Rate at 3 ft: 33 gpm
Shut-Off Head: 53 ft
Normal Running Time: 4 - 6 seconds (short bursts)
Capacity: 2.75 gallons
Inlets: 2 in. (sides) 1-1/4 in. vent (top)
Method of Activation: Pressure switch / circuit board
Shower/bathtub Base Height: 10 in. minimum
Connections: Dishwasher, sink, shower, bathtub, laundry sink, or washing machine
Certified by CSA (IPC, NSPC), IAPMO (UPC)
Dimensions: 13 in. x 17 in. x 9 in.
Weight: 22 lbs

PDF1
018 Sanicom1
PDF1
sanicom instruction manual
PDF1
Sanicom1 specification sheet
WARNING:This product can expose you to chemicals which are known to the State of California to cause cancer, to cause birth defects or other reproductive harm. Wash your hands after installing for uninstalling this product. For more information, go towww.P65Warnings.ca.gov.

Global Trade Identification Numbers (GTIN numbers) for this product. GTINs appear on barcodes and identify products sold by different retailers as the same product.

0859925002183