For full bathroom applications
The Sanibest Pro is a 1 HP pump system used to install a complete bathroom up to 25 feet below the sewer line, or even up to 150 feet away from a soil stack.
It incorporates a grinder system which is ideal for uncontrolled environments in both residential and commercial applications (ie. rental unit, offices, warehouses, etc).
The Sanibest Pro is designed to handle sanitary products that may have been flushed down the toilet; such may consist of condoms, sanitary napkins, q-tips, dental floss, etc.
Discharges the waste through a 3/4 in. or 1 in. rigid pipe. A non-return valve is included on the discharge elbow assembly provided with the system. This elbow can be rotated 360 degrees depending on the discharge installation.
Has been designed with a 1-1/2 in. vent connection on the top of the lid. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent as air needs to freely flow both ways. Note: The use of mechanical vents, air admittance valves or similar devices is not permitted.
Must be connected to Saniflo’s 1.28 GPF / 4.8 LPF rear discharge toilet. These toilets come in round and elongated (ADA compliant) models.
Will also discharge gray water from a sink, bath/shower, urinal, or washing machine (indirect connection). The wastewater will drain into the system via two 2 in. inlets with built-in check valves on either side of the housing. Note that when adding a bathtub/shower, the base should be raised up by a minimum of 8 in. off the floor.
An easy access service panel is located on top of the pump. This will give you easy access to the electrical components such as the capacitor, microswitch, electronic board and membrane.
Pump Type: Grinder
Electrical: 120v - 60Hz / 4.5 amps (max)
Motor: 1 HP oil-filled thermally protected motor
Capacitor Rating: 60 microfarad
Operating Temperature: 104 degrees F (110 degrees F max)
Power Cord Length: 49 in.
Noise level (measured at 3 ft): less than 63 dBa
Discharge Pipe: 3/4 in. or 1 in. diameter
Discharge Rate at 25 ft: 19 gpm
Discharge Rate at 3 ft: 38 gpm
Shut-Off Head: 38 ft
Normal Running Time: 10 - 12 seconds
Capacity: 3.2 gallons
Inlets: 2 in. (side) 1-1/2 in. vent (top)
Method of Activation: Membrane / microswitch
Shower/bathtub Base Height: 8 in. minimum
Connections: Rear outlet toilet, sink, shower/bathtub, washing machine (indirect connection via laundry sink)
Certified by CSA (IPC, NSPC), IAPMO (UPC)
Dimensions: 10-1/2 in. x 20-5/16 in. x 8 in.
Weight: 28 lbs